FIBARO Roller Shutter 2
Product Highlights
The Roller Shutter 2 is radio-controlled and works with motorized roller blinds, awnings, venetian blinds, and gates. Powered by a single-phase AC the Roller Shutter 2 provides accurate positioning of blinds, gates or awnings so they can be set to the position you choose. When teamed with a FIBARO Home Center the module will have an additional power metering feature. Connected devices can be controlled using FIBARO Roller Shutter 2 either via a switch attached directly to it or via the Z-Wave network.
Product Highlights
- Compatible with any Z-Wave Controller
- Superior microprocessor control
- Executive element – electromagnetic, micro-gap relay switch
- Suitable for different types of switches – toggle, momentary, and dedicated roller blind switches
- Dynamic energy and power metering functionality
- This device may be used with all devices certified with Z-Wave certificate and should be compatible with such devices produced by other manufacturers.
- To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulations
- Power supply: 110-240 V AC, 50/60 Hz
- Rated load current: 4.2A for lamps and resistive loads
- 1.7A for motors with compensated power factor (inductive loads)
- Type of supported motor: single-phase AC motors
- Supported limit switches type: electronic and mechanic
- Power consumption: up to 0.8W
- In accordance with EU standards: R&TTE 1999/5/EC RoHS 2011/65/EU
- Operational temperature: 0-35°C
- Active element: micro-gap relay switch μ
- For installation in boxes: Ø ≥ 50mm, depth ≥ 60mm
- Radio protocol: Z-Wave
- Radio signal power: up to 1mW
- Radio frequency: 865.2 MHz IN;
- Range: up to 50 m outdoors, up to 30 m indoors (depending on building materials)
- Dimensions: (L x W x H)): 42.50 x 38.25 x 20.30 mm
- Roller Shutter 2 protects the engine from running for more than 4 minutes. Additionally short break is introduced before changing the direction.